Failure report – PROCESSOR CMP-3 (ULFIA 21-0058, Dynapac 38 82 10)

for compaction meter.

*** All information below should be submitted. ***

Statement	Write here
Date of report :
Organization :
Department :
Respondent, name :
telephone / fax :
e-mail :
Serial number of unit :
revision : hard-/software :
Used on roller :
Roller serial number :

Write here------------

(

How many hours has the processor been in operation when the failure occurred ? (hours =)
Is the correct sequence displayed on the CMV instrument at power up ? (yes/no)
Is the correct frequency range displayed on the status lamp at power up ? (yes/no)
Is the status lamp on continuously ? (yes/no)
Is any error code displayed on the status lamp (number of short flashes) ? (number =)
Is the status lamp flashing when the vibration is on ? (yes/no)
Was any fuse blown on the roller at the time for the processor failure ? ( yes/no)
Was there any other failure on the roller at the time for the processor failure ? ( yes/no)
Did the compaction meter work properly after that the processor was exchanged ? ( yes/no)
Description of the failure :

1

ULFIA Elektronik AB	Doc.no. 21-0058-7902-64

2003-09-25 U.A.	rev. 1	1(1)

Failure report CMP-3

Ulf Andersson

2006-10-27

ULFIA Elektronik AB